FL

Product Description

Feature:

• Bar stock 316St.St.or brass construction
• Moderate pressure characteristics(3000 psi in 316St.St. and 1000 psi in brass)
• Interchangeable parts
• Replaceable filter elements available in filtration levels:0.5, 2, 7.0, 15, 60 and 90 micron.
• Other filter elements available upon request.

Disassembly

Use a suitable wrench to loosen the body from the insert. Then remove the element, spring and sealing gasket.

reassembly

1.Prior to reassembly, clean the filter house and make sure that all other components are clean and free of contaminants.
2.Place the element in the filter body so that the open end of the element is parallel to the element seat diameter.
3.Lubricate the sealing gasket gentiy. The recommended oil:Fluorolube grade T-80. Put the sealing gaske in its place.
4.Mount the sealing gasket on the insert.
5.Place the spring inside the insert.
6.Close the nut manually. Make sure that the sealing gasket is correctly placed.
7.Use a moment wrench to affix the insert more tightly onto the body,according to Table2 below.
8.Connect the filter to the pressure line and check the filter for correct operation. Use liquid leak detectors to ensure there is no leakage.

table 2
Nut Tightening Moment lb-in(N-m)

	Standard Assembly		With no lubrication on the sealing gasket (used for special applications)
	SS	Brass	SS
FL-1/8 FL-3mm	150(17)	135(15)
FL-1/4 FL-6mm	380(43)	345(39)	530(60)
FL-3/8 FL-8mm FL-10mm FL-12mm FL-1/2	530(60)	470(53)	830(94)

Warning! For your safety

Warning! For your safety the system designer and user have the sole responsibility to select products suitable for their special application requirements to ensure the proper installation, operation and maintenance of the product. Application details, material compatibility and product ratings should all be considered in the individual selection. Improper selection or use of products can cause property damage or personal injury.