FLT
FLT download or browse relative PDF file.
Product Description
features
- Bar stock 316St.St.or brass construction
- On-line maintenance
- Interchangeable parts
- Replaceable filter elements available in filtration levels:0.5, 2, 7.0, 15, 60 and 90 micron.
- Other filter elements available upon request.
Disassembly
Use a suitable wrench to loosen the body from the insert. Then remove the element, spring and sealing gasket.
reassembly
1.Prior to reassembly, clean the filter house and make sure that all other components are clean and free of contaminants.
2.Place the element in the filter body so that the open end of the element is parallel to the element seat diameter.
3.Lubricate the sealing gasket gentiy. The recommended oil:Fluorolube grade T-80. Put the sealing gaske in its place.
4.Place the spring inside the insert.
5.Close the nut manually.
6.Use a moment wrench to tighten the nut,according to Table1 below.
7.Connect the filter to the pressure line and check the filter for correct operation. Use liquid leak detectors to ensure there is no leakage.
Table 1
Nut Tightening Moment lb-in(N-m)
| Standard Assembly |
Standard Assembly |
|||
| SS | Brass | SS | Brass | |
| FLT-1/8 FL-3mm FLT-1/4 FLT-6mm |
530(60) | 470(53) | 575(65) | 470(53) |
| FLT-3/8 FLT-8mm FLT-10mm FLT-12mm FLT-1/2 |
630(71) | 470(53) | 680(77) | 470(53) |
Warning! For your safety
Warning! For your safety the system designer and user have the sole responsibility to select products suitable for their special application requirements to ensure the proper installation, operation and maintenance of the product. Application details, material compatibility and product ratings should all be considered in the individual selection. Improper selection or use of products can cause property damage or personal injury.